Configuring The Lens, Tilt Sensor; Manipulating The Rigging Frame - Barco F80 User Manual

GUI – Installation

8.4 Configuring the lens, tilt sensor

When to use the tilt sensor menu
The projector has a built-in tilt sensor that detects the angle at which the projector is mounted. If you are in a
situation where you need to fine-tune the projector because you want to achieve a picture at a specific angle
(e. g. perfectly level, or a perfect fit in a multi-projector setup), you can use the tilt sensor menu as an aide
when adjusting the projector feet, rigging frame or other used mounting mechanisms.
How to read the tilt sensor values
1. In the main menu, select Installation → Lens → Tilt sensor.
Image 8–6 Lens menu, Tilt sensor
The Tilt sensor menu is displayed.
Image 8–7 Example of the tilt sensor menu
If you notice the tilt sensor isn't working correctly (e.g. when compared to a level), you can calibrate
the sensor in the settings menu. For more info, see
page 137.

8.5 Manipulating the rigging frame

When can you manipulate the rigging frame?
You can manipulate the rigging frame in the Pulse menu when projector is mounted in a motorized rigging
frame, otherwise this menu is not present.
How to manipulate the rigging frame?
1. In the main menu, select Installation → Lens → Motorized frame.
74 R5906852 /06 F80
"Advanced settings – Tilt sensor calibration",