Saving The Current Projector Settings In A Profile - Barco F80 User Manual

GUI – Macro's and projector profiles
9.1 Saving the current projector settings in a
profile
Which settings can be saved to a profile?
Profile setting
name
Source
Image
PQ (HDR)
Realcolor P7
Installation
Warp
Blend
Black level
Illumination
Display (3D
settings)
Cooling 2
How to save the current projector settings?
1. In the main menu, select Profiles → Edit.
2. Only if external cooler is installed
106 R5906852 /06 F80
Settings saved
Active source selection & EDID
• All basic image settings: contrast, brightness, saturations, sharpness & gamma
• Used gamma type
• Digital zoom (width / height / factor + enabled/disabled)
• Digital shift (x / y + enabled / disabled)
• Output resolution
Screen luminance & HDR boost value
Color mode & P7 coordinates
• Lens parameters (lens zoom, focus & shift)
• Orientation (mounting & projection)
• Scaling mode
• Position of motorized frame (if used).
• Shutter status (open or closed).
• Warp status enabled / disabled
• Screen size
• Warp file selected (if available)
• Transport delay
Note: Bow and 4 corners warp cannot be saved.
• Blend mask enabled / disabled
• All Masks (top / bottom / left / right) and heights (top / bottom / left / right)
• Blend files enabled / disabled (if available)
• Blend file selected (if available)
• Black level file enabled / disabled
• Black Level file selected (if available)
• Basic black level enabled / disabled
• Black level settings (top / bottom / left / right)
• RGB gain values (Red, Green and Blue values)
• Power setting
• CLO enabled / disabled
• CLO set point
• Display mode used
• Swap eyes on / off
• Swap frame pair on / off
• Dark time and sync delay values
Selected Cooling mode