Using The Mini-Jack Connector Of The Rcu; Remote Control, On/Off Button - Barco F80 User Manual

CAUTION: Replace with the correct battery type. Use two AA size batteries. There is a risk of
explosion if the battery is replaced with an incorrect type.
CAUTION: Replace the battery as explained above. There is a risk of explosion if the battery is
incorrectly installed.

2.2 Using the mini-jack connector of the RCU

Connecting a cable with the mini-jack connector will reset the broadcast address of the RCU to its
default value '0'.
How to use the mini-jack connector
1. Connect a cable with the mini-jack connector (reference 2
2. Connect the other end of the cable with the mini-jack input of the projector.
Image 2–4

2.3 Remote control, on/off button

Purpose of the remote control on/off button
The Pulse remote control unit has at the front side an on/off switch (reference 1
remote control prevents that unwanted commands are send due to an accidental key press. Furthermore,
switching the RCU off will extend the battery life time of the remote control.
To activate the remote control press the on/off button.
To deactivate the remote control press the on/off button again.
Default when (re)placing batteries, is "ON".
Image 2–5
Image
1
Remote Control Unit
2–4) of the RCU.
Image 2–5). Switching off the
R5906852 /06 F80 23