Remote Access - Enable Camera Preview - Barco F80 User Manual

GUI – System Settings
The Remote access menu is displayed.
Image 10–39 Example of the Remote access menu
2. Enable the slider to enable the source preview feature.
Image 10–40 Remote access menu, Source preview is enabled
10.15.2 Remote access – Enable camera preview
Camera preview
Up until Pulse software 2.0.x, you were able to see the footage of the camera when you remotely accessed
the projector. This was a feature you could disable using PToolset.
However, from Pulse 2.1. x onward, this feature is disabled by default and can now be enabled in both
PToolset and the Pulse GUI.
Upgrading your projector from a software version 2.0.x or older to 2.1.x or newer will disable
Camera preview by default. Once the software has been successfully upgraded, you can always opt
to enable this feature again.
How to enable Camera preview
1. In the main menu, select Settings → Maintenance and enter the service code to visualize the hidden
Remote access menu.
Image 10–41 Maintenance menu, Remote access
The Remote access menu is displayed.
130 R5906852 /06 F80