Going From Ready To On; Going From On To Ready; Going From Ready To Eco Standby; Going From Eco To On - Barco F80 User Manual

Getting Started
The background image of the startup screen and info screens can be changed with Projector
Toolset with an installed F80 plug-in.
Description
Plug the 3-prong plug of power cord into a grounded AC outlet. The projector will go to READY mode. During
this stage the system boots and performs the internal check of the boards. The Power On/Off button will
BLINKING WHITE until READY mode is achieved. Once in READY mode, the Power On/Off button will be lit
WHITE.

4.3.3 Going from READY to ON

Description
Press the Power On/Off button (short press) on the projector, or the Power On button on the remote control.
The projector will power ON. The Power On/Off button will BLINK BLUE during the transition from READY to
ON. Once the projector is on, the Power On/Off button will be lit BLUE.
A JSON command (power on) could also be send to make the projector turn in to ON mode.

4.3.4 Going from ON to READY

Description
Press and hold the Power on/off button on the projector for 3 seconds, or press the Power Off button on the
remote control. The projector will power down through a cool down phase. The Power on/off button will BLINK
WHITE during the transition from ON to READY. Once the projector is in READY, thePower on/off button will
be lit WHITE.
A JSON command (power off ) could also be send to make the projector turn in to READY mode.

4.3.5 Going from READY to ECO standby

Description
If ECO Standby mode is enabled in the service menu (refer to the section "GUI - system settings/Standby
ECO", in User Guide) the projector will automatically go to ECO standby mode after a time-out (default 15
minutes). All electronics (including fans, pumps,...) go down except for a very small wake up controller. The
Power on/off button will FLASH WHITE every second.
Another way to switch in ECO mode (when you are in READY mode) is press and hold the Power on/off
button on the projector for 3 seconds, or press the Power Off button on the remote control.
And finally, a JSON command (Go to ECO) could also be send to make the projector turn in to ECO mode.

4.3.6 Going from ECO to ON

Description
Press the Power on/off button on the projector or the Power On button on the remote control. The projector
goes from ECO directly to ON. The projector will go through the same booting phase as on power plugging,
then do the transition from READY to ON. Of course startup-time will be longer then from READY to ON.
An ASCII command (Powr1) could also be send via RS232 to make the projector turn in to ON mode.

4.3.7 Wake on LAN (WOL)

Description
Wake-on-LAN (WOL), the standard ethernet network command, can be used to awakened or to turn on the
projector by network message.
Used alone, the WOL command allows to switch in READY mode. A JSON command must be performed in
addition to make the projector turn in to ON mode:
1. Send WOL.
36 R5906852 /06 F80