Sdi; Hdbase T - Barco F80 User Manual

3.4.4 SDI

Specifications
Parameter 12G-SDI
Standard SMPTE ST-2082-1 and ST-2082-10
standards
Connector Samtec BNC7T-J-P-HN-RA-BH1
Bandwidth 12GHz
Return loss -6dB @ 12GHz
Impedance 75 ohm resistive

3.4.5 HDBase T

The HDBaseT standard allows the link to also be used as a regular network port. In addition to
carrying video data, it can also be connected to regular ethernet network without carry out any video
data.
Due to limitations in the projector and network standards, only the LAN and the HDBaseT should be
used for network traffic, but not both simultaneously. If both are connected simultaneously it might
lead to undefined behavior where traffic is not being sent on the link indicated by the IPaddress.
This is only valid when the projector has a firmware version 2.1 or higher installed.
Specifications
Parameter
Reference specification
Connector
Signal characteristics
Max. cable length (1080p/48b/60Hz)
Max TMDS Clock Frequency
Max video resolution supported
HDCP Pass-Through
IR Extension
RS-232 Extension
10/100Mbps Ethernet Pass-Through
Fallback to 100BaseTx, IEEE 802.3u
USB Over Centre Tap
Power Over Ethernet
Audio
LEDs - HD Base Status
3G-SDI
SMPTE 424M-2006 10bit level A
1x) BNC 75 ohm type IEC 60169-8,
Amendment 2 1997, A
>3 GHz
>10dB at 3GHz
75 ohm resistive
Value
HDBaseT 1.0 Specification, June 2010
Standard RJ-45, 8P8C
HDBaseT
100 m (Cat5e/6), Pixel Clock <=225HHz, Video
Datarate <=5.3Gbps
70 m (Cat5e/6), Pixel Clock >225HHz, Video
Datarate >5.3Gbps
100 m (Cat6a/7), Pixel Clock >225HHz, Video
Datarate >5.3Gbps
270 MHz
4096x2160 @30Hz
Yes, from Source to Projector
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Operation: Green, Left
Link/Mode: Yellow, Right
Input & Communication
R5906852 /06 F80 29