Making Connections; Connector Specifications; Dvi-I - Barco F80 User Manual

Nb.Name Pcs
8 DP 2
9 DL-DVI-D 2
10 HDMI 1
11 HDBaseT 1
12 SDI 2
Regarding the Trigger Output: If these outputs are loaded too heavy, there is a risk that the projector
will go in reset mode, and restart. This causes no damage to the projector, but is an undesirable
response. This will also happen if the startup current for the external equipment is too high, even
though the nominal power consumption is less than 0,5A.

3.3 Making connections

The source switching time is variable and could take few seconds..
Source signal connectivity
The connector panel at the back of the projector is used for all source connections.
Source signal connectivity on the projector is:
• 2x Dual Link DVI-I (DVI-D functionality)
• 2x DisplayPort 1.2
• 1x HDMI 2.0
• 1x HDBaseT
• 1x SDI input (initially designed for 3G-SDI input signals, 12G-SDI signals are now supported)

3.4 Connector specifications

3.4.1 DVI-I

Specifications
Parameter
Connector
Signal characteristics
Max. cable length
Max. pixel rate
Scan format
Max. input data resolution
Bit depth
Description
Standard display port
Dual DVI-I 1.0 (DVI_D
Functionallity).
Standard HDMI 2.0
Standard RJ45 8P8C
Connector
SDI1 is Input, SDI 2 is pass
through. (out)
Purpose
For Projector Input
For Projector Input. These connectors can also
be used to form one uniform image by feeding
half of the image into each connector. HDCP
compliant for sources up 165 Mhz
For Projector Input
For Projector Input
For Projector Input
Value
DVI-I female digital RGB
DVI 1.0, Digital, TMDS
25 m (24 AWG)
330 MHz (dual link), 165 Mhz (single link)
Progressive
1920x1200 60Hz (Single link), 2560x1600 60Hz
(Dual Link), 1920x1200 120 Hz (Dual Link),
1920x2400 @60Hz
8 bit
Input & Communication
R5906852 /06 F80 27