Getting Started - Barco F80 User Manual

Getting Started

4.1 Local Keypad and LCD panel ........................................................................................................34
4.2 Power modes ...............................................................................................................................34
4.3 Power mode transitions.................................................................................................................35
4.4 Status overview ............................................................................................................................37
4.5 Power off projector........................................................................................................................37
4.6 Increasing the projector life time ....................................................................................................38
4.7 Operation in 24/7 Mode.................................................................................................................38
4.8 Using the RCU .............................................................................................................................38
4.9 Projector Address .........................................................................................................................40
4.10 Quick setup via Direct access ........................................................................................................41
About this chapter
This chapter describes how to power up, control and set up your projector setup when the physical installation
process is complete.
How controlling the projector ?
The projector can be controlled by the local keypad, by the remote control unit or by browser application.
Location of the local keypad ?
The local keypad is located on the right side of the projector.
Remote control functions.
This remote control includes a battery powered infrared (IR) transmitter that allows the user to control the
projector remotely. This remote control is used for source selection, control, adaptation and set up.
Other functions of the remote control are :
• switching between operating modes ( ECO, READY, ON).
• switching to "pause" (blanked picture, full power for immediate restarting)
• direct access to all connected sources.
4
R5906852 /06 F80 33