SONET_Usr.bk Page 30 Wednesday, December 13, 2000 11:11 AM
Setting the Interfaces - SDH Operation
Setting Receive Interface
Setting Receive Interface
Description
The receive interface settings should match the network equipment settings of rate and
mapping, and determine the payload to be tested.
TIP:
If you wish to set the OmniBER 720 transmitter and receiver to the same interface
settings, choose
receiver to be configured to the same settings as the transmitter,
1 Choose the required SIGNAL source.
HOW TO:
2 Choose mapping and type of payload.
3 If TU-2 mapping is chosen, and CONCATENATION is enabled, choose the
4 Choose the PATTERN type and PRBS polarity.
30
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
OTHER
SETTINGS CONTROL COUPLED
tributary at which the concatenation begins.
If TU-2, TU-3, TU-12 or TU-11 mapping is chosen, choose the test tributary under
CHANNEL.
. This causes the