Table of Contents
Advertisement
SONET_Usr.bk Page 33 Wednesday, December 13, 2000 11:11 AM
NOT E
TIP:
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Selecting Test Features - SDH Operation
Using Transmit Overhead Setup
INCREASE DIGIT
If BYTE NAMES is chosen, the labels for the ALL COLUMNS overhead bytes
are displayed.
4 If POH (Path Overhead) is chosen, choose the TYPE of overhead within STM-1
under test to be setup.
J1 and J2 bytes can be set under Path Overhead or Trace Messages. H4 byte has
a choice of sequences for TU-12, TU11 and TU-2 mapping:
Full Sequence - 48 byte binary sequence.
Reduced Sequence - Binary count sequence of 0 to 3 i.e. 111111(00 to 11).
COC1 Sequence - Binary count sequence of 0 to 3 i.e. 110000(00 to 11).
5 If TRACE MESSAGES is chosen, see "Setting Overhead Trace Messages "
page 36.
Any bit of an overhead byte which is displayed as x or s cannot be set at any time.
All other bits can be set to 0 or 1.
You can set all overhead bytes to the default state by selecting SETUP
You can set all overhead bytes and test functions to the default state by recalling
Stored Settings [0] on the
OTHER
.
display.
.
DEFAULT
33
Advertisement
Table of Contents
