Start And Stop Commands; Reference Signal; Process Value - Omron SX-F Instruction Manual

Start and stop commands

10-4 Start and stop commands

10-5 Reference signal

10-5-1 Process value

Set start and stop commands via serial communication..
Modbus/DeviceNet
Instance number
42901
42902
42903
42904
Note Bipolar mode is activated if both RunR and RunL is active.
When menu Reference Control [214] is set to "Com" the following parameter
data should be used:
Default
Range
Corresponding to
Communication information
Modbus /DeviceNet
Instance number
Profibus slot /Index
EtherCAT index (hex)
Fieldbus format
Modbus format
It is also possible to send the Process value feedback signal over a bus (e.g.
from a process or temperature sensor) for use with PID Process controller
[380].
Set menu Process Source [321] to F(Bus). Use following parameter data for
the process value:
Default
Range
Corresponding to
Communication information
Modbus /DeviceNet
Instance number
Profibus slot /Index
EtherCAT index (hex)
Fieldbus format
Modbus format
Function
Reset
Run, active together with either RunR or RunL to
perform start.
RunR
RunL
0
-16384 to 16384
-100% to 100% ref
42905
168/64
4b59
Int
Int
0
-16384 o 16384
-100% to 100% ref
42906
168/65
4b5a
Int
Int
Section 10-4
79