Table of Contents
Advertisement
Main Setup [200]
11-2-3 Mains supply voltage [21B]
!Warning This menu must be set according to the VSD product lable and the supply
11-2-4 Motor Data [220]
voltage used. Wrong setting might damage the VSD or brake resistor.
In this menu the nominal mains supply voltage connected to the VSD can be
selected. The setting will be valid for all parameter sets. The default setting,
Not defined, is never selectable and is only visible until a new value is
selected.
Once the supply voltage is set, this selection will not be affected by the Load
Default command [243].
Brake chopper activation level is adjusted using the setting of [21B].
Note The setting is affected by the Load from CP command [245] and if loading
parameter file via EmoSoftCom.
Default:
Not Defined
220-240 V
380-415 V
440-480 V
500-525 V
550-600 V
660-690 V
Communication information
Modbus Instance no/
DeviceNet no:
Profibus slot/index
EtherCAT index (hex)
Fieldbus format
Modbus format
In this menu you enter the motor data to adapt the VSD to the connected
motor. This will increase the control accuracy as well as different read-outs
and analogue output signals.
Motor M1 is selected as default and motor data entered will be valid for motor
M1. If you have more than one motor you need to select the correct motor in
menu [212] before entering motor data.
Note The parameters for motor data cannot be changed during run mode.
Note The default settings are for a standard 4-pole motor according to the nominal
power of the VSD.
Note Parameter set cannot be changed during run if the sets is set for different
motors.
Note Motor Data in the different sets M1 to M4 can be revert to default setting in
menu [243], Default>Set.
21B Supply Volts
Stp
Not defined
A
Not defined
Inverter default value used. Only valid if this parameter is
0
never set.
1
Only valid for SX-F-4 (400V)
3
Only valid for SX-F-4 (400V)
4
Only valid for SX-F-4 (400V)
5
Only valid for SX-F-6 (690V)
6
Only valid for SX-F-6 (690V)
7
Only valid for SX-F-6 (690V)
43381
170/30
4d35
UInt
UInt
Section 11-2
91
Advertisement
Table of Contents
