Preset References [360] - Omron SX-F Instruction Manual

Process and Application Parameters [300]

11-3-7 Preset References [360]

150
Flux Optimization automatically decreases the V/Hz ratio, depending on the
actual load of the motor when the process is in a steady situation. Fig. 79
shows the area within which the Flux Optimization is active.
Default:
Off
1 - 400
Note The maximum possible setting for parameter [355] is limited by Inom/Imot
*120% but not higher than 400%.
Communication information
Modbus Instance no/
DeviceNet no:
Profibus slot/index
EtherCAT index (hex)
Fieldbus format
Modbus format
Motor Potentiometer [361]
Sets the properties of the motor potentiometer function. See the parameter
DigIn1 [521] for the selection of the motor potentiometer function.
Default:
Volatile
Non volatile
Communication information
Modbus Instance no/
DeviceNet no:
Profibus slot/index
EtherCAT index (hex)
Fieldbus format
Modbus format
355 Max Power
Stp
A
Off
0 Off. No power limit
1 -
1 - 400% of motor nominal power
400
43145
169/49
4c49
Long, 1=1%
EInt
361 Motor Pot
Stp Non Volatie
A
Non Volatile
After a stop, trip or power down, the VSD will start always
0
from zero speed (or minimum speed, if selected).
Non Volatile. After a stop, trip or power down of the VSD,
the reference value at the moment of the stop will be mem-
1
orized. After a new start command the output speed will
resume to this saved value.
43131
169/35
4c3b
UInt
UInt
Section 11-3
Off