Nortel Communication Server 1000E Maintenance Manual page 118

118 Replacing equipment
1. Connect the terminal to port 0 with the NTAK19EC cable.
2. Insert the CF card into the Call Server faceplate.
3. Reboot the card by pressing the RST button on the faceplate
of the Call Server. When prompted enter F to "force board to
boot from faceplate drive" (prompt may appear twice).
Figure 20
Upgrade boot sequence
The Installation Tool banner screen appears:
Figure 21
Installation Tool banner
4. Enter y for both software warnings to proceed with the
upgrade.
Note: PE/EPE is not applicable for this upgrade as it only
applies to large systems.
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 04.01 4 June 2010
Copyright © 2004-2010 Nortel Networks. All Rights Reserved.