Table of Contents
Advertisement
Figure 14. Removing the air shroud
Next steps
1.
Install the air
shroud.
Installing the air shroud
Prerequisites
1. Follow the safety guidelines listed in
2. If applicable, connect the PERC battery cable to the connector on the system board.
Steps
1. Insert the hook on the air shroud into the slot on the chassis.
NOTE:
Ensure that the SATA cables are routed behind the air shroud clip.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Lower the air shroud until the blue clip locks in place.
38
Installing and removing system components for PowerEdge C6525
Safety
instructions.
Advertisement
Table of Contents
