Signode Little David LD16AE 2.0 Operator's Manual page 78

Refer to Table 1 for the following example. If you wanted to order a, "Sliding
Block", for your mirror image cartridge. Find the part in the corresponding table.
The standard image part number is, "CAC60‐0134‐4". The cartridge your ordering
for is mirror image. Check the column under the heading, "MI". If a, "MI", is in
the row for the part you are ordering, than "MI" must be added to the end of the
part number. In this example "MI" is indicated in the row for the, "Sliding Block".
So the part number would be as follows. "CAC60‐0134‐4SS".
Example 3:
Refer to Table 1 for the following example. If you wanted to order a, "Front Roller
Arm", for your stainless steel, mirror image cartridge. Find the part in the
corresponding table. The part number for a standard image, carbon steel
cartridge is, "CAC60‐0001‐6". The cartridge your ordering is stainless steel and
mirror image. Check the columns under the heading, "SS" and "MI". If a, "SS" and
"MI", are in the rows for the part you are ordering, than "SS" and "MI" must be
added to the end of the part number. In this example "SS" and "MI" are indicated
in the row for the, " Front Roller Arm ". So the part number would be as follows.
"CAC60‐0001‐6SMI". Take note that a part number is limited to 15 characters. So
in this example one of the "S" in "SS" was dropped.
Example 4:
Refer to Table 1 for the following example. This example deals with converting
hardware from carbon steel to stainless steel. If you wanted to order a, "M4 x 12
Button Head", for your stainless steel, cartridge. Find the part in the
corresponding table. The part number for a standard, carbon steel cartridge is,
"FBHME012P10". The cartridge your ordering is stainless steel. Check the
columns under the heading, "SS". If a, "P‐S" or "B‐S", is in the row for the part you