Signode Little David LD16AE 2.0 Operator's Manual page 19

Front suppressor
The front suppressor is designed to keep the box firmly pressed against the drive rollers during
the flap folding operation. The downward pressure can be adjusted by moving the collar on the spring
holding shaft.
Squeezers
The squeezers are used to square up the top of the box and to insure the proper butting of the
flaps in preparation of the tape.
To adjust the squeezers, start a sealed box through the machine and press the "stop" button when
the box is between the two squeezer wheels. Then push each squeezer wheel snug against the box.
Tighten the m8 t-nuts. The machine is now ready to process this size box. If a different size box must be
sealed, the squeezer wheels must be reset.
Counterweight and head adjustment
The counterweight springs, as shown below, are designed to ease the manual up and down travel
of the head. To adjust the head height, turn the small hand knob counterclockwise; then turn the large
hand wheel until the desired height has been reached. Turn the hand knob clockwise to lock the head in
this position.
Page | 15