Arm Mounting; Figure 3-16: Tighten The Panel Mounting Clamp Screws - Acnodes PC 5170 User Manual

Figure 3-16: Tighten the Panel Mounting Clamp Screws

3.7.3 Arm Mounting

The PC 5170 is VESA (Video Electronics Standards Association) compliant and can be
mounted on an arm with a 100mm interface pad. To mount the PC 5170 on an arm,
please follow the steps below.
The arm is a separately purchased item. Please correctly mount the arm onto
Step 1:
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 100mm interface pad. If the mounting arm is not VESA
compliant, it cannot be used to support the PC 5170 flat panel PC.
Once the mounting arm has been firmly attached to its surface, lift the PC 5170
Step 2:
flat panel PC onto the interface pad of the mounting arm.
Align the retention screw holes on the mounting arm interface with those in the
Step 3:
PC 5170 Flat Panel PC
Page 63