Insert the PSU module and bracket assembly into the chassis and attach the
Step 2:
PSU bracket to the chassis with the previously removed retention screws.
Secure the PSU module to the chassis by reinserting the previously removed
Step 3:
retention screws through the bottom panel.
Bundle the cables of the new PSU module and secure them with a plastic tie
Step 4:
similar to the old PSU module.
Reconnect all previously disconnected power connectors to the motherboard
Step 5:
and disk drives.
Reattach the elevated platform.
Step 6:
Replace the back cover.Step 0:
Step 7:
4.6 System Cooling Fan Replacement
Please read the warnings at the beginning of Section 4.3 before attempting to access any
PC 5170 internal components.
If the system cooling fans have been damaged, they must be replaced. To replace the
system cooling fans, please follow the steps below.
4.6.1 Remove the Old System Cooling Fans
Step 1:
Remove the back cover (Section 4.3.1).
Step 2:
Detach and remove the elevated platform (see Section 4.3.2).
Step 3:
Remove the plastic tie that bundles the fans wires together and disconnect the
system cooling fans from the motherboard (Figure 4-13).
Page 78
PC 5170 Flat Panel PC
ACNODES ® Corp.