Psu Module Replacement; Remove The Old Psu; Figure 4-8: Dimm Socket Clip Locations - Acnodes PC 5170 User Manual

Locate the DIMM socket on the motherboard near the right of the chassis. Push
Step 2:
down on the white levers of the socket until the DIMM module is dislodged from
the socket (Figure 4-8).

Figure 4-8: DIMM Socket Clip Locations

Slowly slide the new DIMM module along the plastic guides at both ends of the
Step 3:
socket. Press the DIMM module down into the socket until it clicks into position
and the two handles have automatically locked the memory module into place.

4.5 PSU Module Replacement

Please read the warnings at the beginning of Section 4.3 before attempting to access any
PC 5170 internal components.
If the PSU module has been damaged it must be replaced. To replace the PSU module,
please follow the steps below.

4.5.1 Remove the Old PSU

Step 1:
Remove the back cover (Section 4.3.1).
Step 2:
Detach and remove the elevated platform (see Section 4.3.2).
Step 3:
Disconnect all PSU connections including those to the motherboard (Figure 4-9)
and any disk drives.
PC 5170 Flat Panel PC
Step 0:
Page 75