Figure 3-13: Secure the Chassis
3.7.2 Panel Mounting
To mount the PC 5170 flat panel PC into a panel, please follow the steps below.
NOTE:
The maximum panel thickness should be no more than 6mm.
Select the position on the panel to mount the PC 5170.
Step 1:
Cut out a section of the panel that corresponds to the rear panel dimensions of
Step 2:
the PC 5170. Take care that the panel section that is cut out is smaller than the
overall size of the metal frame that surrounds the PC 5170 but just large enough
for the rear panel of the PC 5170 to fit through (Figure 3-14).
PC 5170 Flat Panel PC
Page 61