Figure 3-7: Remove CD Drive
The CD drive blank plate assembly consists of a blank plate and two brackets
Step 6:
that attach the assembly to the chassis. The two brackets each have two screws
that attach them to the blank plate. Remove the four screws that attach the
brackets to the blank plate. Figure 3-8 shows the underside of the CD drive
blank plate assembly with the four screws to be removed.
Figure 3-8: CD Drive Blank Plate Assembly
Attach the two brackets to a CD drive with the four previously removed screws.
Step 7:
Be sure to orient the brackets properly before attaching them to the CD drive.
Figure 3-9 shows two views of a CD drive with the brackets attached and the
proper retention screws to use.
PC 5170 Flat Panel PC
Page 55