Table of Contents
Advertisement
5 Commissioning
5.1 Installation
Notice!
Possible damage to device!
• Commissioning and maintenance work is only permitted to be performed when the power is
switched off. The power cable must also be disconnected from the power supply and device.
• Do not use force! Handle all the modules and components carefully.
• All covers and components, accessories, hardware and cables must be installed or secured
before the device is connected to the power supply and switched on.
• Observe the ESD information (see
Important installation information
• Ambient conditions must be taken into account.
• The device must be installed on a flat, clean and burr-free surface.
• When connecting cables, the bend radius must be taken into account.
• The device must be installed such that viewing is optimized for the user (see the technical data for infor-
mation regarding the viewing angle).
5.1.1 Installation cutout requirements
When installing the Power Panel, it is important to ensure that the surface and wall thickness meet the following
conditions:
Properties of the installation cutout
Permissible deviation from the evenness
Note: This condition must also be met with a built-in device.
Permitted surface roughness in the area of the seal
Min. wall thickness
Max. wall thickness
Notice!
The degree of protection of the device (see technical data) can only be maintained if the device is
installed in an appropriate housing with at least the same degree of protection per the above require-
ments.
Notice!
The device must ultimately be installed in a protective housing with sufficient rigidity (per UL 61010-1
and UL 61010-2-201).
5.1.2 Mounting with retaining clips
Figure: Retaining clip
Power Panel T80 User's manual V1.03
"Protection against electrostatic discharge" on page
The retaining clips are designed for a certain thickness of the material
to be clamped (max. 6 mm, min. 2 mm).
A large flat-blade screwdriver is needed to tighten and remove the
screws.
Devices must be installed on a flat, clean and burr-free surface; tight-
ening screws on an uneven area can result in damage to the display or
the ingress of dust and water.
See also
"Installation cutout requirements" on page
Commissioning
6).
Value
≤0.5 mm
≤120 µm (R z 120)
2 mm
6 mm
29.
29
Advertisement
Table of Contents
