Commissioning; Commissioning From A Safety Point Of View; Proper Use Of The Machine Or System - B&R Mobile Panel 40 User Manual

Commissioning

3 Commissioning
3.1 Commissioning from a
This handheld terminal was developed, manufactured, tested and documented in accordance with ergonomic
guidelines and relevant
served, there is no danger of damage to property or injury to personnel under normal operating conditions.
The instructions contained in this manual must be observed exactly in every case. Otherwise, hazard sources may
be created or the integrated
In addition to the safety guidelines in this manual, all applicable occupational
lines must be observed.
Danger!
In the end application, the 24 VDC power supply of the
with max. 3.15 A and UL 248 certification must be used for this.
Warning!
The machine manufacturer must configure the handheld
ger and risk assessment. The following
- Correct cable length for restricting the work area
- Stop button necessary or permitted
- Sufficient safety category for the respective application
• The device is only permitted to be operated in good order and condition and in accordance with
the instructions in this manual.
• The user must possess the required level of training and detailed knowledge of the intended
use as specified in the user's manual.
• The safety guidelines in the following chapters must be taken into account.
• Additional important information regarding
and certifications" and must be observed.
3.1.1 Proper use of the
Mobile Panel devices are intended for use in monitoring, configuring and operating machinery. Examples include:
• Injection molding machines
• Robots
• Machine tools
• Textile machines
• Printing machines
• Theater backdrops
• Etc.
Intended use in normal operating modes, for example:
• Automatic
Intended use in special semiautomatic or manual special operating modes, for example:
• Setup
• Teach-in
• Test runs
• Etc.
An enabling device with one or two enable switches and a stop button are available as
66
safety point of view
safety standards. When the guidelines for intended use and
safety equipment in the handheld terminal may be disabled.
safety
machine or system
safety
device must be adequately protected! A fuse
control device
aspects must be considered:
safety and EMC is provided in chapter
safety functionality are ob-
and accident prevention guide-
properly according to the dan-
"Standards
safety functions.
Mobile Panel 40/50 User's manual V1.80