B&R Power Panel T80 User Manual page 30

Commissioning
Procedure
1. Insert the device into the front of the prepared, burr-free and flat installation cutout. For the dimensions of the
installation cutout, see section "Dimensions" for the individual devices.
2. Install the retaining clips on the device. To do this, insert the clips into the openings on the sides of the device
(indicated by the orange circles). The number of openings may vary depending on the size of the device.
3. Slide the retaining clips all the way to the back of the openings.
4. Now secure the retaining clips to the wall or control cabinet by tightening the screws with a flat-blade screw-
driver.
Torque limiting is built into the retaining clips.
30
Figure: Using the retaining clips
Figure: Sliding the retaining clips back
Figure: Securing the retaining clips
Power Panel T80 User's manual V1.03