Cable For Non-Isco Detectors; Non-Isco Detector Cable, P/N 69-2134-171 - Teledyne Foxy R1 Instruction Manual

Table 1-8 Non-Isco Pump Cable, P/N 69-2134-170
Connector
1.6.3 Cable for non-Isco
Detectors
Table 1-9 Non-Isco Detector Cable, P/N 69-2134-171
Connector
Foxy
Pin Color Type
1 BLK Input
2 BRN Output
3 RED Output
4 ORN Common
5 YEL Output
6 GRN Not used
K N/A Shield
A cable is available to connect the fraction collector to a non-Isco
detector. Part number 69-2134-171 is a six-foot long cable with
one end terminated as a 8-pin mini-DIN connector. The other end
is stripped and tinned for connection to the external device.
Pin Color Type
1 BLK Common
2 BRN Input
3 RED Not used
4 ORN Output
5 YEL Input
6 GRN Input
7 BLU Common
8 VIO Input
K N/A Shield
® ®
R1 and Foxy R2 Fraction Collectors
Section 1 Introduction
Description
Count: pump volume signal
Pump pause: stops pump between
tubes and at end of run
Valve output: control signal for
optional high flow diverter valve
Circuit common
+24 VDC Output: power for optional
high flow diverter valve
Earth ground
Description
Analog common for use with pin 8
Ext peak:
Event: pulse delivered at tube change
Inject: starts an inject cycle
Tube Advance
Circuit common
Analog detector signal: used for peak
detection
Earth ground
1-11