Commissioning The Device; Gauge Pressure, Absolute Pressure From The Differential Pressure Series And Absolute Pressure From The Gauge Pressure Series; Commissioning For Gases - Siemens SITRANS 7MF03.0 Compact Operating Instructions

5.4 gauge pressure, absolute pressure from the differential pressure series and absolute pressure from the gauge
Procedure
Switch on the power supply.
● Product name and firmware version appear briefly on the display.
● The measured values are shown on the display.
For a device without a display, you read off the current output as follows:
– Over the remote control (e.g. SIMATIC PDM).
– With a DC current measuring device.
Result
The device is now ready for operation.
5.3

Commissioning the device

Ensure that the operating data matches the values specified on the nameplate.
The parameters for damping, characteristic curve, start of scale value/full scale value and fault
current must agree with the settings of the measuring point.
You can find more detailed information on operation and configuration in the operating
instructions.
The following commissioning cases are typical examples. Configurations different from those
listed here may be useful depending on the system configuration.
5.4 gauge pressure, absolute pressure from the differential pressure
series and absolute pressure from the gauge pressure series
5.4.1

Commissioning for gases

Requirement
All valves are closed.
SITRANS P320/P420 (mA/HART)
Compact Operating Instructions, 06/2018, A5E38874562-AA
Connecting the device (Page 33)
Commissioning
pressure series
39