GE Vivid 3 Pro Service Manual page 75

GE M S
EDICAL YSTEMS
D 2300164-100, R
IRECTION
9) Release the front stopper (item C in
locking pin's base upwards, and then turning it towards you.
10) Remove the three silica gel (moisture absorbing) bags (item 7 in
underneath the ultrasound unit.
11) Raise the control console (monitor) by pressing the release grip located under the unit's front handle
and remove the two cartons (item 8 in
console. These cartons contain the external cables and accessories.
12) Lower the control console to its lowest position.
13) Remove the manuals (item 4 in
the ultrasound unit.
14) Press the brake pedal, located near the bottom of the front of the unit, to the right, to prevent the
wheels from swiveling, as described in the Swivel Brake Label section, page 1-24.
15) Carefully pull the unit backwards from the platform base onto the ramp and roll it down to the floor.
16) Press the brake pedal, located near the bottom of the front of the unit, to the left, to lock the wheels,
as described in the Parking Label section, page 1-24.
17) Verify the contents of the shipping carton, as described in
page 3 - 13.
3-12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
7
EVISION
Figure 3-10 Front Stopper Location
Figure 3-8
Section 3-3 - Receiving and Unpacking the Equipment
V ™ 3 P
IVID
Figure 3-10 below) by sliding the metal sleeve located at the
Figure 3-8 on page 3-11) from underneath the control
on page 3-11) from the compartment on the left side of
Verifying the Shipping Crate Contents
/V ™ 3 S M
RO IVID ERVICE
Figure 3-10, above) located
ANUAL
on