GE Vivid 3 Pro Service Manual page 69

GE M S
EDICAL YSTEMS
D 2300164-100, R
IRECTION
CAUTION: When using sharp tools to open packing materials, take care to avoid cutting or damaging
the contents.
Note: Unless otherwise specified, referenced items are shown in
1) Cut and remove the three securing steel strips (item 16).
2) Release the eight Clip-lok
wall. (Refer to the procedure described in
3) Release the eight Clip-lok
4) Remove the small cartons containing the probes and peripheral options (items D and E in
below) from the wooden crate.
5) Remove the console control support back foam (item 11 in
6) Remove the keyboard support foam located in front of the keyboard (item 10 in
7) Remove the back support foam located in front of the rear wheels (item 9 in
8) Remove the top cover by opening the six clips fastening it to the right and left walls. For details on
opening the clips, refer to
9) Remove the right wall (item 6) and the left wall (item 7) by opening the three clips fastening each to
the base.
10) Cut and remove the antistatic sheet (item 2 in
taking care not to damage the antistatic cover.
11) Remove the antistatic cover (item 4 in
3-6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
7
EVISION
TM
clips (item 15) securing the front wall (item 13) and remove the front
TM
clips securing the back wall (item 14) and remove the back wall.
Figure 3-3 Probes and Peripherals in Original Packaging
Section 3-3-1-1
Section 3-3 - Receiving and Unpacking the Equipment
V ™ 3 P
IVID
Figure 3-1
Section 3-3-1-1 on page 3-4).
Figure
on page 3-4.
Figure 3-4 below) that is wrapped around the unit,
Figure 3-4).
/V ™ 3 S M
RO IVID ERVICE ANUAL
on page 3-4.
Figure 3-3
3-3, above).
Figure 3-3, above).
Figure 3-3, above).