Setting Modes - 3Com CoreBuilder 2500 User Manual

13-10 C 13: A
HAPTER DMINISTERING

Setting Modes

Default
Top-Level Menu
system
interface
ethernet
summary
route
areas
fddi
detail
arp
defaultRouteMetric
atm
statistics
multicast
interface
bridge
mode
udphelper
linkStateData
ip
priority
routing
neighbors
ipx
areaID
icmpRouterDiscovery
routerID
appletalk
cost
ospf
partition
snmp
delay
rip
stubDefaultMetric
analyzer
hello
ping
virtualLinks
script
retransmit
statistics
statistics
logout
dead
password
OSPF R
OUTING
Table 13-3 Field Attributes for Interface Statistics Display (continued)
Field
transmitError
receiveError
mismatchHello
mismatchDead
mismatchMask
mismatchAreaID
mismatchAreaType Number of interface area type mismatches that were detected
receivedUnknown
authError
packetXsum
lsaXsumError
Use this command to set the OSPF mode for each interface. The mode
can be off or active. To run OSPF routing, set the mode to active.
To set the OSPF interface mode to active, you must enable IP routing. See
Chapter 10 "Administering IP Routing," for information about how to
enable IP routing.
The default is off.
To set the interface mode:
1 From the top level of the Administration Console, enter:
ip ospf interface mode
2 Enter the interface.
3 Enter the interface mode:
Description
Number of general transmit errors
Number of general receive errors
Number of hello packet interval mismatches that were detected
Number of router dead interval mismatches that were detected
Number of subnet mask mismatches that were detected
Number of interface area ID mismatches that were detected
Number of unknown LSAs that were received
Number of authentication errors
Number of packet checksum errors since interface came up
Number of LSA checksum errors that were detected
or
off active
.