Setting Rip Triggered Updates; Setting The Sap Mode - 3Com CoreBuilder 2500 User Manual

12-10 C 12: A
HAPTER DMINISTERING
Setting RIP
Triggered Updates
Default
Top-Level Menu
system
ethernet interface
fddi
route
mode
atm server
enhanced
bridge forwarding
triggered
ip
rip
ipx
sap
appletalk
statistics
snmp
analyzer
script
logout
Setting the SAP
Mode
Default
Top-Level Menu
system
ethernet
interface
fddi
route
mode
atm
server
triggered
bridge
forwarding
ip
rip
ipx
sap
appletalk
statistics
snmp
analyzer
script
logout
IPX R
OUTING
The
ipx rip triggered
broadcast newly learned routes.
The default setting is enabled.
To configure IPX RIP broadcast timing:
1 From the top level of the Administration Console, enter:
ipx rip triggered
2 Enter the triggered update mode:
disabled — IPX broadcasts routes 3 seconds after learning them.
enabled — IPX broadcasts routes immediately after learning them.
Example:
Enter Trigger Update mode for RIP (disabled,enabled) [enabled]:
Use this command to select a SAP mode that is appropriate for your
network. SAP can operate in any of these modes:
off — The system does not process any incoming SAP packets and
does not generate any SAP packets of its own.
passive — The system processes all incoming SAP packets, but it does
not broadcast periodic or triggered SAP updates or respond to SAP
requests.
active — The system processes all incoming SAP packets, responds to
explicit requests for routing information, and broadcasts periodic and
triggered SAP updates.
The default mode is off.
To set the SAP mode:
1 From the top level of the Administration Console, enter:
ipx sap mode
2 Enter the SAP mode (
Press Return to accept the existing value in brackets.
command directs the IPX protocol when to
, , or
off passive active
).