Setting Sap Triggered Updates; Displaying Ipx Summary Statistics; Displaying Statistics - 3Com CoreBuilder 2500 User Manual

Setting SAP
Triggered Updates
Default
Top-Level Menu
system
ethernet interface
fddi
route
mode
atm server
triggered
bridge forwarding
ip
rip
ipx
sap
appletalk statistics
snmp
analyzer
script
logout

Displaying Statistics

Displaying IPX
Summary Statistics
Top-Level Menu
system
interface
ethernet
route
fddi
summary
server
atm
rip
forwarding
bridge
sap
rip
ip
forwarding
sap
ipx
statistics
appletalk
snmp
analyzer
script
logout
The
ipx sap triggered
broadcast newly learned SAP server addresses.
The default setting is enabled.
To configure IPX SAP broadcast timing:
1 From the top level of the Administration Console, enter:
ipx sap triggered
2 Enter the triggered update mode:
disabled — IPX broadcasts SAP server addresses 3 seconds after
learning them.
enabled — IPX broadcasts SAP server addresses immediately after
learning them.
Example:
Enter Trigger Update mode for SAP (disabled,enabled) [enabled]:
Use this command to display IPX summary, RIP, SAP, and forwarding
statistics from the Administration Console.
To display IPX summary statistics, from the top level of the Administration
Console, enter:
ipx statistics summary
This example shows IPX summary statistics:
IPX forwarding is enabled, RIP is active, SAP is active,
RIP Trig enabled, SAP Trig enabled
Received
1170878
command directs the IPX protocol when to
Transmitted
565099

Setting SAP Triggered Updates 12-11

Dropped Msg Pool Empty
0 0