Renesas R0E521000CPE00 User Manual page 68

R0E521000CPE00 User's Manual
3) Setting trace write conditions
OR
4) Realtime-trace Write Condition dialog box
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 66 of 92
Pick up
3. Usage (How to Use the Emulator Debugger)
Setting trace write conditions
You can specify a condition for the cycles to be written into the
trace memory.
- Total
All cycles are written into memory.
- Pick up
Only the cycles in which the specified condition was met are
written into memory.
- Exclude
Only the cycles in which the specified condition was not met are
written into memory.
When you have selected "Pick up" or "Exclude" for the trace write
condition, click this button. The Realtime-trace Write Condition
dialog box shown below will appear.
Write mode
Only the cycle in which the specified Start event occurred
A range of cycles from when the specified Start event occurred to
when the specified Start event became nonexistent
A range of cycles from when the specified Start event occurred to
when the specified End event occurred