Table of Contents
Advertisement
R0E521000CPE00 User's Manual
Cautions to Be Taken for Connecting the Power Supply:
Do not use any power cable other than the one that is included with the product.
The power cable included with the product has its positive and negative poles color-coded by red and black,
respectively.
Pay attention to the polarities of the power supply. If its positive and negative poles are connected in reverse,
the internal circuit may be broken.
Do not apply any voltages exceeding the product's rated power supply voltage (5.0 V ±5%). Extreme voltages
may cause a burn due to abnormal heat or cause the internal circuit to break down.
Cautions to Be Taken for Turning On the Power:
Turn ON the power of the emulator and user system as simultaneously as possible. Turn OFF the power of the
emulator and user system as simultaneously as possible.
Do not leave only the user system powered on, because of leakage current the internal circuits may be damaged.
When turning ON the power again after shutting OFF the power, wait about 10 seconds.
Cautions to Be Taken for Handling This Product:
Use caution when handling the main unit. Be careful not to apply a mechanical shock.
Do not touch the connector pins of the emulator main unit and the target MCU connector pins directly. Static
electricity may damage the internal circuits.
Do not pull this emulator by the communications interface cable or the flexible cable for connecting the user
system. And, excessive flexing or force may break conductors.
Caution to Be Taken for System Malfunctions:
If the emulator malfunctions because of interference like external noise, do the following to remedy the trouble.
(1) Press the RESET switch of the emulator.
(2) If normal operation is not restored after step (1), shut OFF power to the emulator once and then reactivate it.
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 9 of 92
CAUTION
Precautions for Safety
Advertisement
Table of Contents
