Table of Contents
Advertisement
R0E521000CPE00 User's Manual
5. Troubleshooting
This chapter describes how to troubleshoot when this product does not work properly.
5.1 Flowchart to Remedy the Troubles
Figure 5.1 shows the flowchart to remedy the troubles from when power to the emulator is activated until the emulator
debugger starts up. Check this while the user system is disconnected. For the latest FAQs visit the Renesas Tools Homepage.
Starting up the emulator debugger
Init dialog box of emulator
Check the lot no. displayed
MCU Setting dialog box of
"Connected" of the Output
Emulator debugger startup completed
Figure 5.1 Flowchart to remedy the troubles
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 84 of 92
http://www.renesas.com/tools
Turning on emulator
Not normal
Upper panel LED
of emulator
Not normal/Error displayed
debugger displayed
Not normal/ Error displayed
on the Init dialog box
Setting Init dialog box
Not normal/ Error displayed
emulator debugger
Setting MCU dialog box
window displayed
Check the connection of power supply cable .
See "2. 5 Connecting the Power Supply of the Emulator "
( page 30)
1. Check the operating environment etc. of the emulator debugger.
See the user's manual (online manual) of the emulator debugger.
2. Reinstall the emulator debugger.
Check that the USB interface cable is connected and the USB
driver is installed properly.
See 5.2. 2 MCU Setting Dialog Box Does Not Appear at
Emulator Debugger Startup" (page 85)
Error displayed
See 5.2. 3
Errors Occur at Emulator Debugger Startup
( page 86).
5. Troubleshooting
Advertisement
Table of Contents
