Renesas R0E521000CPE00 User Manual page 36

R0E521000CPE00 User's Manual
POWER
CLOCK
RESET
RUN
After turning the power ON.
Figure 2.16 Target status LEDs display when the emulator starts up normally
(when user system connected: setting the POWER selection jumper to EXT POWER side and use system is ON)
POWER
CLOCK
RESET
After turning the power ON.
Figure 2.17 Target status LEDs display when the emulator starts up normally
(when user system connected: setting the POWER selection jumper to EXT POWER side and use system is OFF)
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 34 of 92
When the user system connected:
(Power selection jumper: EXT,
user system is ON)
If the POWER LED does not light, shut
off the system. Then check the setting
of the jumper switches and if the power
is properly supplied to the user system.
LED3
LED4
LED5
LED6
When the user system connected:
(Power selection jumper: EXT, user
system is OFF)
Because the power of the user system is off,
POWER LED does not light. RESET LED
lights.
LED 3
LED4
LED5
RUN LED6
POWER LED3
CLOCK LED4
RESET LED5
RUN LED6
After starting up the emulator debugger.
POWER LED3
CLOCK LED4
RESET LED5
RUN LED6
After starting up the emulator debugger.
2. Setup
: ON
: OFF
: ON
: OFF