Led Display When The Emulator Starts Up Normally - Renesas R0E521000CPE00 User Manual

R0E521000CPE00 User's Manual

2.7.4 LED Display When the Emulator Starts Up Normally

After the emulator starts up, check the status of the LEDs to see whether the emulator operation is enabled or not. Figure 2.14
shows the positions of the emulator status LEDs.
System status LEDs
Target status LEDs
Figure 2.14 Positions of the system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 and LED2 of the system status LEDs are lit immediately after the power is activated. If it is not lit, shut
off the emulator and check the power supply for the emulator is properly connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.15 when the user system is not connected and as shown in Figure 2.16 when a
user system is connected. After turning on the power, the LED4 (CLOCK) and LED5 (RESET) light on. Check the
target status LEDs display normally after starting up the emulator debugger.
When the target status LEDs do not display as shown in Figures 2.15 to 2.17, refer to "5. Troubleshooting" (page 84).
POWER
CLOCK
RESET
RUN
After turning the power ON.
Figure 2.15 Target status LEDs display when the emulator starts up normally (when user system not connected)
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 33 of 92
SYSTEM
LED1 POWER
POWER
STATUS
SAFE
SAFE
LED2
COMPACT EMULATOR
R0E521000CPE00
POWER
LED3
POWER
TARGET
CLOCK
CLOCK
STATUS
RESET
RESET
RUN
RUN
LED6
COMPACT EMULATOR
When the user system NOT
connected:
The POWER LED does not light.
LED3 POWER
LED4 CLOCK
LED5 RESET
LED6
POWER USB
5.0V
-
J1
MADE IN JAPAN
MADE
LED 3
LED4
LED5
RUN LED6
After starting up the
emulator debugger.
2. Setup
SW1
+
J2
5.0V
JP2
3.3V
EXT
JP1
INT
: ON
: OFF