Renesas R0E521000CPE00 User Manual page 67

R0E521000CPE00 User's Manual
(3) Trace point setup window
1) Opening the trace point setup window
2) Trace point setting window
OR
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 65 of 92
3. Usage (How to Use the Emulator Debugger)
Trace point
Clicking this toolbar button opens the trace point setting window.
Or you can select "Trace point" from "Trace (T)" of "View (V)"
menu for the same effect.
Trace point setting window
Select "Enable the trace point function" in the Init dialog box.
The trace point setup is the same for the hardware breakpoint
setting.
Specifying a trace measurement area
You can specify a trace range for the trace event.
- Break
64K cycles of instruction execution before the user program
stopped is recorded.
- Before
64K cycles of instruction execution before a trace point
condition was met is recorded.
- About
32K cycles of instruction execution before and after a trace
point condition was met is recorded.
- After
64K cycles of instruction execution after a trace point
condition was met is recorded.
- Full
64K cycles of instruction execution after a trace began is
recorded.