Attaching The Ferrite Core; Connecting The Power Supply For The Emulator - Renesas R0E521000CPE00 User Manual

R0E521000CPE00 User's Manual

2.4 Attaching the Ferrite Core

Attach the ferrite core included with this product close to the DC plug of the power cable. Without the ferrite core it may cause
interference.
The power cable should be wound around the ferrite core as shown in Figure 2.10, and close the ferrite core until it clicks.
Figure 2.10 Attaching the ferrite core

2.5 Connecting the Power Supply for the Emulator

Connect the power supply for the emulator to the power connector (J1). The specification of the power supply for the emulator
is listed in Table 2.5.
Table 2.5 Specification of power supply of the emulator
Power supply voltage
Figures 2.11 and 2.12 show the specifications of the power connector (J1) and an applicable plug, respectively.
Electrode (+)
Figure 2.11 Power connector specifications
Notes on Connecting a Power Supply of the Emulator:
The power cable included in this product package is colored red (+) and black (-).
Be careful about the polarity of the power supply. Connecting to the wrong electrode could destroy internal
circuits.
Do not apply a voltage exceeding the specified voltage of the product (5.0 V ±5%), because it may cause burn
injuries and the failure of internal circuits.
Use the power supply which complies with CE marking requirements.
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 30 of 92
DC 5.0 V±5％/2 A
Electrode (-)
Figure 2.12 Applicable plug specifications
φ 1.7mm(Inside diameter)
CAUTION
φ 4.75mm
2. Setup