Toro Z Master 7500-D Series Service Manual page 87

Motion Control Assembly (Cont.)
Installation
1. Install the four new flange bushings in the LH motion control.
2. Install motion control lever in the LH motion control.
3. Install the flat washer on motion control lever.
4. Install the two spring washers with the crown side of the washers facing out.
5. Install the nut and tighten so it is snug.
6. Install the spring leaf with carriage bolt and nut.
7. Install the neutral switch to the motion control lever.
8. Install the wire harness anchor to the motion control lever.
9. Secure the LH control assembly to the frame with a bolt and the pivot tube.
10. Install the plug connector to the neutral switch.
11. Install the wiring harness in the wire anchor located on the LH motion control assembly.
12. Install the lock nut from the damper motion control to the LH motion control assembly.
13. Secure the front pump linkage assembly to the LH motion control assembly with a bolt, washer, and nut.
NOTE: The washer must be installed between the LH motion control assembly and the ball joint on the
front pump linkage assembly.
14. Install the two bolts and nuts retaining the LH steering handle assembly to the LH motion control lever.
15. For adjustments on the control handles and the motion control neutral lock,
Control Neutral Lock Pivot," chapter 5, page 5-35
5, page 5-31.
16. Install the two screws retaining the LH motion control cover assembly.
17. Start the unit, disengage the park brake lever, and run for about 5 minutes operating the forward and reverse
handle forward/reverse. Move the motion control lever to the neutral position and observe the rear tire for
movement. If the rear tire creeps in the forward position, perform a neutral adjustment. A slight creep in
reverse is allowable.
5-34
Table of Contents
CHASSIS
and "Adjusting the Motion Control Damper," chapter
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
see "Adjusting the Motion