Pto Switch; Testing - Toro Z Master 7500-D Series Service Manual

PTO Switch

The PTO switch (Figure 14) provides battery voltage from the ignition switch to the control module.

Testing

1. Remove the control panel from the right console.
2. Disconnect the PTO switch from the wire harness.
3. With the switch in the OFF position (button pushed IN):
- Terminal A and B should NOT have continuity (open)
- Terminals B and C should have continuity (closed)
4. With the switch in the ON position (button pushed IN):
- Terminal A and B should have continuity (closed)
- Terminals B and C should NOT have continuity (open)
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
ELECTRICAL
Figure 14
8-13
Table of Contents