Toro Z Master 7500-D Series Service Manual page 46

Yanmar Engine Replacement (Cont.)
Removal (Cont.)
57. Use an overhead hoist, attached at the designated lift points, raise engine slightly and ensure the engine and
transmission are free of the chassis (Figure 36).
Tech Tip: Raising the rear of the engine first and lifting at an angle, may assist in removal.
58. Continue to slightly raise and move the engine rearward until engine is free of the machine.
NOTE: Drive shaft spline will separate on its own during engine removal (Figure 37).
4-24
Table of Contents
ENGINE
Figure 36
Figure 37
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition