Toro Z Master 7500-D Series Service Manual page 149

Charging the Hydraulic System (Cont.)
9. After the lift cylinder moves normally, proceed to step 11.
10. Operate the traction control levers in the forward and reverse directions. The drive wheels should rotate in the
proper direction.
11. Adjust the traction control levers to the NEUTRAL position. See operator's manual for additional information.
12. Lower the machine to the ground.
13. If the transmission or a wheel motor was replaced or rebuilt, operate the traction circuit on a level ground so
that the two drive wheels rotate slowly for 10 minutes.
14. Operate the machine by gradually increasing its work load to full over a 10 minute period.
15. Stop the machine. Check the hydraulic fluid level in the hydraulic reservoir and add correct quantity of fluid if
necessary. See operator's manual for additional information.
16. Check the hydraulic components for leaks and tighten any loose connections.
7-18
Table of Contents
DRIVE
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition