Toro Z Master 7500-D Series Service Manual page 124

Deck Wings (Cont.)
Installation
1. Roll the wing towards the center deck section and align.
2. Install the front and rear deck pins and secure with bolts.
3. Install the locking cotter pin to the outer wing ram lift pin.
4. Install the two cap screws securing the wing stop bracket.
5. Lower the center deck.
6. Install the rear tire, remove the jack stand.
7. Install the belt, see "Belt Installation," chapter 6, page 6-22.
8. Perform purge procedure,
9. Test run to operating temperature and test deck operation.
6-30
Table of Contents
DECK
see "Charging the Hydraulic System," chapter 7, page 7-17.
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition