Deck Hydraulics (Deck Fold Cylinder) (Cont.)
Installation
1 Install the deck fold cylinder onto the deck.
2. Install the locking cotter pins (two on each cylinder) on both ends of the deck fold cylinder.
3. Install the screws securing the deck-stop bracket to the machine.
4. Verify the hydraulic lines are cleaned from debris, attach the hydraulic lines to the lift cylinder.
5. Install the center floor pan.
6. Install the two lynch pins securing the outer belt guard to the deck. Repeat for opposite side.
7. Install the two lock nuts and two carriage bolts securing the inner belt guard. Repeat for opposite side.
8. Perform purge procedure,
9. Test run to operating temperature and test deck operation.
6-26
Table of Contents
DECK
see "Charging the Hydraulic System," chapter 7, page 7-17.
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition