Toro Z Master 7500-D Series Service Manual page 139

Drive System (Cont.)
Removal (Cont.)
12. Loosen the reservoir clamps. Remove all seven reservoir lines.
Tech Tip: Slide the clamps away from the end of the hose and lightly tighten to not lose any clamps for re-
assemble.
13. Remove the two nuts securing the hydro tank front mount and remove the front hydro tank mount bracket.
14. Slide the hydro tank up and slightly backwards, then lift out of the machine (Figure 6).
NOTE: Residual fluid my spill while removing the tank.
15. Before removing the deck drive shaft mark the orientation of the deck drive shaft and gear box shaft (for roll
pin orientation) (Figure 7).
7-8
Table of Contents
DRIVE
Figure 6
Figure 7
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition