Toro Z Master 7500-D Series Service Manual page 33

ENGINE
Yanmar Engine Replacement (Cont.)
Removal (Cont.)
15. Disconnect the vent line hose from both torque motors and cap/plug the lines and fittings (Figure 11).
A
B
A
Figure 11
A. Straight Fitting B. Vent Line Asm.
16. Cut the zip ties securing the wire harness to the heat deflector panel.
17. Remove the fasteners securing the heat deflector panel. Remove the panel.
18. Remove the operator's floor pan from the machine.
19. Remove the fuel tank vent line from the ROPS tube, slide the line through the three clamps. Repeat for
opposite side.
20. Mark and remove fuel supply and return line for both left and right fuel tank (Figure 12).
Figure 12
4-11
Z Master 7500-D Series Service Manual
Table of Contents
March 2018 - Digital Edition