Toro Z Master 7500-D Series Service Manual page 83

Motion Control Damper (Cont.)
Installation
1. Install the damper with ball joint end that has the Belleville washer into the frame. Torque the lock nut to 200
in-lbs. (22.6 Nm) (Figure 21).
2. Install the other end of the damper to the motion control assembly, normally in the center hole and tighten the
lock nut to 200 in-lbs. (22.6 Nm).
5-30
Table of Contents
CHASSIS
Figure 21
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition