Toro Z Master 7500-D Series Service Manual page 80

CHASSIS
Front Seat Mount (Cont.)
Installation
1. Before placing the seat mount on the machine, replace vent line zip ties and retainer clips as needed (Figure
18).
Figure 18
2. Place the seat mount on the machine.
3. Install vent line retaining clips in appropriate mount location.
4. Install the four screws located in the corners of the seat mount.
5. Place the U-bolt into the correct position then place the lock nuts on the U-bolt, tighten.
6. Install the wire harness by using two retainer clips on the back side of the seat mount.
7. Install remaining wire harness clip in appropriate mount hole with new zip tie and retaining clip.
5-27
Z Master 7500-D Series Service Manual
Table of Contents
March 2018 - Digital Edition