Yanmar Engine Replacement (Cont.)
Installation
1. Remove the front half of the deck drive shaft from the gear box,
chapter 6, page 6-14.
2. Install the front half of the drive shaft onto the rear shaft (splined).
3. Collapse the two halves of drive shaft together and secure to the transmission assembly.
NOTE: Once the drive shaft is cleared during install, it can move freely (Figure 38).
4. Using an overhead hoist, move the engine and transmission forward and down into the engine compartment
until transmission mounts can be aligned.
NOTE: Make sure all hoses and wiring are free from engine compartment before install.
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
ENGINE
see "Deck Replacement - 96 in. Deck,"
Figure 38
4-25
Table of Contents